Filter
Top Products
34 CHAPTER 5: GVRP CONFIGURATION GUIDE
Configuration Procedure ■ Configure Switch A
# Enable GVRP globally.
<SwitchA> system-view
[SwitchA] gvrp
# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through.
[SwitchA] interface Ethernet 1/0/1
[SwitchA-Ethernet1/0/1] port link-type trunk
[SwitchA-Ethernet1/0/1] port trunk permit vlan all
# Enable GVRP on Ethernet 1/0/1.
[SwitchA-Ethernet1/0/1] gvrp
[SwitchA-Ethernet1/0/1] quit
# Configure Ethernet 1/0/2 to be a trunk port and to permit the packets of all the
VLANs to pass through.
[SwitchA] interface Ethernet 1/0/2
[SwitchA-Ethernet1/0/2] port link-type trunk
[SwitchA-Ethernet1/0/2] port trunk permit vlan all
# Enable GVRP on Ethernet 1/0/2.
[SwitchA-Ethernet1/0/2] gvrp
[SwitchA-Ethernet1/0/2] quit
# Configure Ethernet 1/0/3 to be a trunk port and to permit the packets of all the
VLANs to pass through.
[SwitchA] interface Ethernet 1/0/3
[SwitchA-Ethernet1/0/3] port link-type trunk
[SwitchA-Ethernet1/0/3] port trunk permit vlan all
# Enable GVRP on Ethernet 1/0/3.
[SwitchA-Ethernet1/0/3] gvrp
[SwitchA-Ethernet1/0/3] quit
■ Configure Switch B
# Configure Ethernet 1/0/1 and Ethernet 1/0/2 to be trunk ports and to permit the
packets of all the VLANs to pass through. Enable GVRP globally and enable GVRP
on the two ports. # The configuration on Switch B is similar to that on Switch A.
■ Configure Switch C
# Create VLAN 5.
<SwitchC> system-view
[SwitchC] vlan5
[SwitchC-vlan5]