Filter
Top Products
Configuring GVRP 35
# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through. Enable GVRP globally and enable GVRP on the port. # The
configuration on Switch C is similar to that on Switch A.
n
For simplicity, the following provides only configuration steps. For configuration
commands, refer to “Configure Switch C” on page 34.
■ Configure Switch D
# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through. Enable GVRP globally and enable GVRP on the port.
# Create VLAN 8.
■ Configure Switch E
# Configure Ethernet 1/0/1 to be a trunk port and to permit the packets of all the
VLANs to pass through. Enable GVRP globally and enable GVRP on the port.
# Create VLAN 5 and VLAN 7.
■ Display the static VLAN registration information on Switch A, Switch B, and
Switch C.
# Display the dynamic VLAN information on Switch A.
[SwitchA] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist:
5, 7, 8,
# Display the dynamic VLAN information on Switch B.
[SwitchB] display vlan dynamic
Total 3 dynamic VLAN exist(s).
The following dynamic VLANs exist:
5, 7, 8,
# Display the dynamic VLAN information on Switch E.
[SwitchE] display vlan dynamic
Total 1 dynamic VLAN exist(s).
The following dynamic VLANs exist:
8
■ Set the registration mode of Ethernet 1/0/1 on Switch E to fixed, and display
the dynamic VLAN registration information on Switch A, Switch B, and Switch
E.
# Set the registration mode of Ethernet 1/0/1 on Switch E to fixed.
[SwitchE] interface Ethernet 1/0/1
[SwitchE-Ethernet1/0/1] gvrp registration fixed
# Display the dynamic VLAN information on Switch A.