Filter
Top Products
242 CHAPTER 26: XRN CONFIGURATION GUIDE
# Configure the fabric name as hello.
[3Com] sysname hello
# Configure the authentication mode as simple and password as welcome.
[hello] XRN-fabric authentication-mode simple welcome
2 Configure Switch B.
# Bring up the fabric ports.
<3Com> system-view
[3Com] fabric-port GigabitEthernet 1/1/1 enable
[3Com] fabric-port GigabitEthernet 1/1/2 enable
# Configure the unit ID as 2.
[3Com] change self-unit to 2
# Configure the unit name as Unit2.
[3Com] set unit 2 name Unit2
# Configure the fabric name as hello.
[3Com] sysname hello
# Configure the authentication mode as simple and password as welcome.
[hello] XRN-fabric authentication-mode simple welcome
Perform the same configurations on Switch C.
3 After the above configuration, use the display ftm information command to
view the running status of the XRN fabric.
[hello] display ftm information
FTM State : HB STATE
Unit ID : 1 (FTM-Master)
Fabric Type : Ring
Fabric Auth : Simple
Fabric Vlan ID : 4093
Left Port : Normal
Right Port : Normal
Advertise : Send = 5, Receive = 3
Advertise ACK : Send = 0, Receive = 5
Heart Beat : Send = 20, Receive = 0
Left Port : Index = 255, IsEdge = 0
Right Port : Index = 25, IsEdge = 0
Units Num Left : 1
Units Num Right : 3
Units Num Backup: 2