Filter
Top Products
132 CHAPTER 15: ROUTING CONFIGURATION GUIDE
# Configure route summarization to prevent network 30.0.0.0/8 from being
advertised.
[SwitchA-ospf-1] asbr-summary 30.0.0.0 255.0.0.0 not-advertise
# Redistribute the static routes.
[SwitchA-ospf-1] import-route static
■ Configure Switch B.
The configuration on Switch B is the same as that in method 1. Refer to
“Configure Switch B.” on page 130.
Complete Configuration In the following complete configuration, the import-route command and the
route-policy command are used to filter routing information (method 1). For the
complete configurations of other methods, refer to the related configuration
procedures.
■ Perform the following configuration on Switch A.
#
router id 1.1.1.1
#
acl number 2000
rule 0 deny source 30.0.0.0 0.255.255.255
rule 1 permit
#
vlan 100
#
vlan 200
#
interface Vlan-interface100
ip address 10.0.0.1 255.0.0.0
#
interface Vlan-interface200
ip address 12.0.0.1 255.0.0.0
#
ospf 1
import-route static route-policy ospf
area 0.0.0.0
network 10.0.0.0 0.255.255.255
#
route-policy ospf permit node 10
if-match acl 2000
#
ip route-static 20.0.0.0 255.0.0.0 12.0.0.2 preference 60
ip route-static 30.0.0.0 255.0.0.0 12.0.0.2 preference 60
ip route-static 40.0.0.0 255.0.0.0 12.0.0.2 preference 60
#
■ Perform the following configuration on Switch B.
#
router id 2.2.2.2
#
vlan 100
#
interface Vlan-interface100