Filter
Top Products
68 CHAPTER 13: AUTO DETECT CONFIGURATION GUIDE
■ Create detected group 9 on Switch C; detect the reachability of IP address
10.1.1.3, with the next hop being 192.168.1.1/24, and the detecting number
being 1.
Applicable Products
Configuration Procedure Configure IP addresses for the interfaces according to Figure 19. The configuration
procedure is omitted here.
■ Configure Switch A
# Enter system view.
<SwitchA> system-view
# Create detected group 8.
[SwitchA] detect-group 8
# Detect the reachability of 10.1.1.4, with the next hop being 192.168.1.2, and
the detecting number being 1.
[SwitchA-detect-group-8] detect-list 1 ip address 10.1.1.4 nexthop 1
92.168.1.2
[SwitchA-detect-group-8] quit
# Configure a static route to Switch C.
[SwitchA] ip route-static 10.1.1.4 24 192.168.1.2
# Configure the master static route, which is valid when the detected group is
reachable.
[SwitchA] ip route-static 10.1.3.1 24 192.168.1.2 detect-group 8
# Configure the backup static route, and set its preference to 80. The backup
route is valid when the detected group is unreachable.
[SwitchA] ip route-static 10.1.3.1 24 192.168.3.2 preference 80
■ Configure Switch C
# Enter system view.
<SwitchC> system-view
# Create detected group 9.
[SwitchC] detect-group 9
Product series Software version Hardware version
Switch 5500 Release V03.02.04 All versions
Switch 5500G Release V03.02.04 All versions
Switch 4500 Release V03.03.00 All versions