Filter
Top Products
5. Configurator
Host name
This is the name that will be returned, along with the IP address in response to the UDP broad-
cast query for projectors/touch panels.
DNS server
Computers, Projectors, Touch panels connected to a network are referenced by their IP ad-
dress. The only problem is that remembering IP addresses is not easy. If you need to use
hundreds of addresses then it will become impossible to remember them. This is why domain
names are created. Internet names (domain and host names) are just aliases to these IP ad-
dresses. When you use an Internet address it is automatically translated to an IP address. In
fact a program or device that translates those Internet names to IP addresses is called a DNS
Server.
Via entering an IP address
1. Select the Connection properties tab (a). (image 5-7)
The right pane changes to the connection setup page.
2. Click on the radio button next to A projector connected on the network to select the Ethernet connection
(b).
3. Click on the radio button in front of IP address (c).
4. Enter the IP address (d).
Note: An address contains 4 octets with a maximum value of 255.
5. Click OK to make the connection.
Image 5-7
Make connection via entering IP address
Via entering a host name
1. Select the Connection properties tab (a). (image 5-8)
The right pane changes to the connection setup page.
2. Click on the radio button next to A projector connected on the network to select the Ethernet connection
(b).
3. Click on the radio button in front of Host name (c).
52
R5976924 PROJECTOR TOOLSET 16/04/2009