Filter
Top Products
6-2 Maintenance Chapter 6
MultiPASS Guidelines
Follow these guidelines to avoid damage to your MultiPASS and harm to you or
others:
❑ Place the MultiPASS on a stable surface. Do not use an angled stand. Avoid
setting the unit in direct sunlight.
❑ Do not install the MultiPASS near devices that contain magnets or generate
magnetic fields, such as speakers.
❑ Do not subject the MultiPASS to strong physical shock or vibration.
❑ Make sure the area where you use the unit is free from dust.
❑ Keep the MultiPASS clean. Dust accumulation can prevent the unit from
operating properly.
❑ To ensure proper electrical contact, make sure the unit is firmly plugged in.
❑ Never pull on the cord to unplug the MultiPASS. Pull on the plug itself.
❑ Do not overload the electrical outlet where the MultiPASS is plugged in.
❑ For your safety, unplug the MultiPASS during electrical storms.
❑ When the power cord is disconnected, the image memory is completely
erased. Therefore, before you begin cleaning the MultiPASS, be sure to print
any faxes stored in its memory (see pages page 4-20).
❑ If you disconnect the MultiPASS while it is waiting to send a document, you
will have to set the MultiPASS to send your document again once the unit is
reconnected.
❑ To avoid damage to the unit from overheating, do not block the exhaust vent.
Install the unit approximately 4 inches (10 cm) away from walls or other
equipment.