Filter
Top Products
Chapter 1 Introduction 1-11
Introduction
❑ To ensure reliable operation of the MultiPASS and to protect it from
overheating (which can cause it to operate abnormally and create a fire risk),
never block or cover any openings on the unit by placing it on a bed, sofa, rug,
or other similar surface. Do not place the unit in a closet or built-in
installation, or near a radiator or other heat register unless proper ventilation
is provided.
❑ Only operate the MultiPASS from the type of power source indicated on the
unit’s label. If you are not sure of the type of power available, consult your
dealer or local power company.
❑ The MultiPASS is equipped with a three-prong, grounding-type plug provided
with a third (grounding) pin. This plug will only fit into a grounding-type
outlet. This is a safety feature. If you are unable to insert the plug into your
outlet, contact an electrician to replace your outlet. Do not defeat the safety
purpose of the grounding-type plug by breaking off the third prong or using a
3-to-2 adapter.
❑ Do not allow anything to rest on the power cord, and do not locate the unit
where the cord will be walked on. Make sure the cord is not knotted or kinked.
❑ If you use an extension cord with the MultiPASS, make sure that the total of
the ampere ratings on the products plugged into the extension cord does not
exceed the extension cord ampere rating. Also make sure that the total ampere
rating of all products plugged into the wall outlet does not exceed the current
amperage of the circuit breaker.
❑ Do not push objects of any kind into the slots or openings on the cabinet as
they may touch dangerous voltage points or short out parts. This could result
in fire or electric shock.
❑ Do not allow small objects (such as pins, paper clips, or staples) to fall into the
MultiPASS. If something does fall into it, unplug the unit immediately and call
the Canon Customer Care Center.
❑ To avoid spillage in or around the unit, do not eat or drink near the unit. If you
spill liquid or if any substance falls into the unit, immediately unplug the unit
and call the Canon Customer Care Center.
❑ Always unplug the MultiPASS before moving or cleaning it.
❑ Whenever you unplug the MultiPASS, wait at least five seconds before you
plug it in again.
❑ During electrical storms, disconnect the power cord from the power outlet.
(Please note that any documents stored in the unit’s memory will be deleted
when you unplug the unit.)