Filter
Top Products
Preface
iii
Users in the U.S.A.
PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE
EQUIPMENT
A. Location
Supply a suitable table, cabinet, or desk. See Appendix A for the unit’s
dimensions and weight.
B. Order Information
1. Only a single line, touch-tone or rotary telephone set is to be used.
2. Order an RJ11-C modular jack (USOC code), which should be
installed by the phone company. If the RJ11-C jack is not present,
installation cannot occur.
3. Order a normal business line from your telephone company’s business
representative. The line should be a regular voice grade line or the
equivalent. Use one line per unit.
DDD (DIRECT DISTANCE DIAL) LINE
-or-
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU
COMMUNICATE OVERSEAS
C. Power Requirements
This equipment should be connected to a standard 120 volt AC, three-wire
grounded outlet only. Do not connect this unit to an outlet or power line
shared with other appliances that cause “electrical noise”. Air conditioners,
electric typewriters, copiers, and machines of this sort generate electrical
noise which often interferes with communications equipment and the
sending and receiving of documents.
n
Canon recommends an individual line following industry standards, e.g. the
2500 (Touch Tone) or 500 (Rotary/Pulse Dial) telephones. A dedicated
extension off a PBX unit without “Call Waiting” can be used with your
MultiPASS. Key telephone systems are not recommended because they send
non-standard signals to individual telephones for ringing and special codes,
which may cause a fax error.