Filter
Top Products
2-171
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
pending (virtual server submode)
pending (virtual server submode)
To set the pending connection timeout, use the pending command in the SLB virtual server
configuration submode. To restore the default, use the no form of this command.
pending timeout
no pending
Syntax Description
Defaults The default pending timeout is 30 seconds.
Command Modes SLB virtual server configuration submode
Command History
Usage Guidelines This command is used to prevent denial-of-service (DOS) attacks. The pending connection timeout sets
the response time for terminating connections if a switch becomes flooded with traffic. The pending
connections are configurable on a per-virtual-server basis.
Examples This example shows how to set the number to wait for a connection to be made to the server:
Cat6k-2(config-slb-vserver)# pending 300
Related Commands advertise (virtual server submode)
show module csm vserver redirect
timeout Seconds to wait before a connection is considered unreachable.
Range is from 1 to 65535.
Release Modification
CSM release 2.2(1) This command was introduced.
CSM-S release 1.1(1) This command was introduced.