Filter
Top Products
2-6
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
port (CAPP UDP submode)
port (CAPP UDP submode)
To set the port number for CAPP UDP connections, use the port command in the CAPP UDP submode.
To remove the port from the configuration, use the no form of this command.
port port_num
no port
Syntax Description
Defaults The no form of this command sets the port to 5002.
Command Modes CSM CAPP UDP submode
Command History
Examples This example shows how to set the port for CAPP connections:
Cat6k-2(config-slb-capp-udp)# 50
Related Commands capp udp
port_num Specifies the UDP port number. Enter a value of 1 to 65535.
Release Modification
CSM release 2.2(1) This command was introduced.
CSM-S release 1.1(1) This command was introduced.