Filter
Top Products
3-91
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 3 Commands Specific to the Content Switching Module with SSL
standby redirects
standby redirects
To enable HSRP filtering of Internet Control Message Protocol (ICMP) redirect messages, use the
standby redirects command. Use the no form of this command to disable the HSRP filtering of ICMP
redirect messages.
standby redirects [enable | disable] [timers advertisement holddown] [unknown]
no standby redirects [unknown]
Syntax Description
Defaults The defaults are as follows:
• HSRP filtering of ICMP redirect messages is enabled if you configure HSRP on an interface.
• advertisement is 60 seconds.
• holddown is 180 seconds.
Command Modes Proxy-VLAN configuration submode
Command History
Usage Guidelines You can configure the standby redirects command globally or on a per-interface basis. When you first
configure HSRP on an interface, the setting for that interface inherits the global value. If you explicitly
disable the filtering of ICMP redirects on an interface, then the global command cannot reenable this
functionality.
enable (Optional) Allows the filtering of ICMP redirect messages on interfaces that
are configured with HSRP, where the next-hop IP address may be changed
to an HSRP virtual IP address.
disable (Optional) Disables the filtering of ICMP redirect messages on interfaces
that are configured with HSRP.
timers (Optional) Adjusts HSRP-router advertisement timers.
advertisement (Optional) HSRP-router advertisement interval in seconds; valid values are
from 10 to 180 seconds.
holddown (Optional) HSRP-router holddown interval in seconds; valid values are
from 61 to 3600.
unknown (Optional) Allows sending of ICMP packets to be sent when the next-hop
IP address that is contained in the packet is unknown in the HSRP table of
real IP addresses and active virtual IP addresses.
Release Modification
SSL Services Module
Release 2.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
CSM-S release 1.1(1) This command was introduced.