Filter
Top Products
2-16
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
failover (fault tolerant submode)
failover (fault tolerant submode)
To set the time for a standby CSM to wait before becoming an active CSM, use the failover command
in the SLB fault-tolerant configuration submode. To remove the failover configuration, use the no form
of this command.
failover failover-time
no failover
Syntax Description
Defaults Failover time is 3 seconds.
Command Modes SLB fault-tolerant configuration submode
Command History
Examples This example shows how to set a failover period of 6 seconds:
Cat6k-2(config-slb-ft)# failover 6
Related Commands ft group
show module csm ft
failover-time Amount of time the CSM must wait after the last heartbeat message
is received before assuming the other CSM is not operating; the range
is from 1 to 65535.
Release Modification
CSM release 1.1(1) This command was introduced.
CSM-S release 1.1(1) This command was introduced.