Filter
Top Products
2-56
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
address (probe submode)
address (probe submode)
To specify a destination IP address for health monitoring, use the address command in SLB probe
configuration submode. To remove the address, use the no form of this command.
address ip-address [routed]
no address ip-address
Syntax Description
Defaults This command has no default settings.
Command Modes SLB probe configuration submode
Command History
Usage Guidelines Multiple addresses can be configured for a DNS probe. For an ICMP probe, you can configure one
address. Allows the probes to cross the firewall to check the link to the host on the other side. ICMP is
the only probe that supports the address parameter without the routed option, which is used for firewall
load balancing.
Examples This example shows how to configure an IP address of the real server:
Cat6k-2(config-slb-probe-icmp)# address 101.23.45.36
Related Commands probe
show module csm probe
ip-address Specifies the real server’s destination IP address.
routed (Optional) Specifies that the probe is routed according to the CSM
routing table.
Release Modification
CSM release 2.1(1) This command was introduced.
CSM-S release 1.1(1) This command was introduced.