Filter
Top Products
3-95
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 3 Commands Specific to the Content Switching Module with SSL
standby track
standby track
To configure HSRP to track an object and change the hot standby priority based on the state of the object,
use the standby track command. Use the no form of this command to remove the tracking.
standby [group-number] track object-number [decrement priority]
no standby [group-number] track object-number [decrement priority]
Syntax Description
Defaults The defaults are as follows:
• group-number is 0.
• priority is 10.
Command Modes Proxy-VLAN configuration submode
Command History
Usage Guidelines This command ties the hot standby priority of the router to the availability of its tracked objects. Use the
track interface or track ip route global configuration command to track an interface object or an IP
route object. The HSRP client can register its interest in the tracking process by using the standby track
command commands and take action when the object changes.
When a tracked object goes down, the priority decreases by 10. If an object is not tracked, its state
changes do not affect the priority. For each object configured for hot standby, you can configure a
separate list of objects to be tracked.
The optional priority argument specifies how much to decrement the hot standby priority when a tracked
object goes down. When the tracked object comes back up, the priority is incremented by the same
amount.
When multiple tracked objects are down, the decrements are cumulative, whether configured with
priority values or not.
Use the no standby group-number track command to delete all tracking configuration for a group.
group-number (Optional) Group number to which the tracking applies.
object-number Object number in the range from 1 to 500 representing the object to be
tracked.
decrement priority (Optional) Amount by which the hot standby priority for the router is
decremented (or incremented) when the tracked object goes down (or comes
back up).
Release Modification
SSL Services Module
Release 2.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
CSM-S release 1.1(1) This command was introduced.