Filter
Top Products
3-79
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 3 Commands Specific to the Content Switching Module with SSL
standby delay minimum reload
standby delay minimum reload
To configure a delay before the HSRP groups are initialized, use the standby delay minimum reload
command. Use the no form of this command to disable the delay.
standby delay minimum [min-delay] reload [reload-delay]
no standby delay minimum [min-delay] reload [reload-delay]
Syntax Description
Defaults The defaults are as follows:
• min-delay is 1 second.
• reload-delay is 5 seconds.
Command Modes Proxy-VLAN configuration submode
Command History
Usage Guidelines The min-delay applies to all subsequent interface events.
The reload-delay applies only to the first interface-up event after the router has reloaded.
If the active router fails or you remove it from the network, the standby router automatically becomes
the new active router. If the former active router comes back online, you can control whether it takes over
as the active router by using the standby preempt command.
However, in some cases, even if you do not use the standby preempt command, the former active router
resumes the active role after it reloads and comes back online. Use the standby delay minimum reload
command to set a delay for HSRP group initialization. This command allows time for the packets to get
through before the router resumes the active role.
We recommend that you use the standby delay minimum reload command if the standby timers
command is configured in milliseconds or if HSRP is configured on a VLAN interface of a switch.
In most configurations, the default values provide sufficient time for the packets to get through and
configuring longer delay values is not necessary.
The delay is canceled if an HSRP packet is received on an interface.
min-delay (Optional) Minimum time (in seconds) to delay HSRP group initialization after
an interface comes up.
reload-delay (Optional) Time (in seconds) to delay after the router has reloaded.
Release Modification
SSL Services Module
Release 2.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
CSM-S release 1.1(1) This command was introduced.