Filter
Top Products
2-21
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
hw-module csm standby config-sync
hw-module csm standby config-sync
To synchronize the configuration between the active CSM and standby CSM, enter the hw-module csm
standby config-sync command on the active CSM:
hw-module csm slot standby config-sync
Syntax Description
Defaults Route processor mode.
Command Modes Global configuration
Command History
Usage Guidelines You can synchronize the configurations between the active and standby CSMs in a single chassis or in
separate chassis.
Enter this command after you have configured both the active and standby CSMs for synchronization.
Enter this command every time you want to synchronize the configuration.
Synchronization happens over the fault-tolerant VLAN. Since traffic over the fault-tolerant VLAN uses
broadcast packets, we recommend that you remove all devices from the fault-tolerant VLAN except
those that are necessary for communication between the active and standby CSMs.
If you do not enter the alt standby_ip_address command on the active CSM before you synchronize the
configuration, the VLAN IP addresses on the backup CSM will be removed.
Examples This example shows how to synchronize the configuration between the active and standby CSMs:
Router# hw-module csm 5 standby config-sync
%CSM_SLB-6-REDUNDANCY_INFO:Module 5 FT info:Active:Bulk sync started
%CSM_SLB-6-REDUNDANCY_INFO:Module 5 FT info:Active:Manual bulk sync completed
Related Commands ft group
ip address (VLAN submode)
priority (fault tolerant submode)
slot Specifies the slot of the active CSM.
Release Modification
CSM release 4.2(1) This command was introduced.