Filter
Top Products
2-8
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
clear module csm
clear module csm
To force the active CSM to become the standby module, use the clear module csm command.
clear module csm [slot | all] arp-cache ip-address connections [real | vserver] counters ft active
linecard-configuration sticky [1-255 | all]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged
Command History
Usage Guidelines When a connection is closed, a reset (RST) is sent to both the client and the server. Counters reset all
the CSM statistics information, except for the show mod csm X tech-support counters, which are reset
any time that you run the show command. The linecard-configuration command forces a soft-reset of
the CSM, which erases all existing connections and run-time information. The CSM then reloads its
configuration from Cisco IOS. This process takes about 3 seconds.
The ft active command is used to force the active CSM to the failover state. Fault tolerance preempt
must not be enabled.
slot (Optional) Specifies the CSM location in the switch. Range is from 1
to 9.
all (Optional) Applies to all online CSM modules.
arp-cache ip-address Clears the SLB ARP cache.
connections Specifies connections.
real (Optional) Clears SLB connections for the real servers.
vserver (Optional) Clears SLB connections for a virtual server.
counters Clears SLB statistics.
ft active Clears the CSM fault tolerance state to force a failover.
linecard-configuration Clears the configuration database stored in the SLB linecard
sticky Specifies sticky.
1-255 (Optional) Clears the designated sticky group; range is from 1 to 255.
all (Optional) Clears all sticky entries from the sticky database.
Release Modification
CSM release 3.2(1) This command was introduced.
CSM-S release 1.1(1) This command was introduced.