IPv6 Routing Commands 1131
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the IPv6 neighbors.
console(config)#show ipv6 neighbors
Neighbor Last
IPv6 Address MAC Address isRtr State Updated
Interface
-------------------- ----------------- ----- ------- ---------
show ipv6 route
Use the show ipv6 route command in User EXEC or Privileged EXEC mode
to display the IPv6 routing table. The output of the command also displays
the IPv6 address of the default gateway and the default route associated with
the gateway.
Syntax
show ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol |
interface-type interface-number] [best]
Syntax Description
Parameter Description
ipv6-address Specifies an IPv6 address for which the best-matching route
would be displayed.
protocol Specifies the protocol that installed the routes. Is one of the
following keywords: connected, ospf, static.
ipv6-prefix/ prefix-
length
Specifies an IPv6 network for which the matching route would
be displayed.
2CSPC4.X8100-SWUM102.book Page 1131 Friday, March 15, 2013 8:56 AM