Filter
Top Products
Command Groups 140
ipv6 ospf mtu-ignore
Disables OSPF maximum transmission unit
(MTU) mismatch detection.
IC
ipv6 ospf network
Changes the default OSPF network type for the
interface.
IC
ipv6 ospf priority
Sets the OSPF priority for the specified router
interface.
IC
ipv6 ospf retransmit-
interval
Sets the OSPF retransmit interval for the
specified interface.
IC
ipv6 ospf transmit-delay
Sets the OSPF Transmit Delay for the specified
interface.
IC
ipv6 router ospf
Enters Router OSPFv3 Configuration mode. GC
maximum-paths
Sets the number of paths that OSPF can report
for a given destination.
ROSV3
nsf
Enables OSPF graceful restart. ROSV3
nsf helper
Allows OSPF to act as a helpful neighbor for a
restarting router.
ROSV3
nsf helper strict-lsa-
checking
Requires that an OSPF helpful neighbor exit
helper mode whenever a topology change occurs.
ROSV3
nsf restart-interval
Configures the length of the grace period on the
restarting router.
ROSV3
passive-interface
Sets the interface or tunnel as passive. IC
passive-interface default
Enables the global passive mode by default for all
interfaces.
ROSV3
redistribute
Configures the OSPFv3 protocol to allow
redistribution of routes from the specified source
protocol/routers.
ROSV3
router-id
Sets a 4-digit dotted-decimal number uniquely
identifying the Router OSPF ID.
ROSV3
show ipv6 ospf
Displays information relevant to the OSPF
router.
PE
show ipv6 ospf abr
Displays the internal OSPFv3 routes to reach
Area Border Routers (ABR).
PE
Command Description Mode
a
2CSPC4.X8100-SWUM102.book Page 140 Friday, March 15, 2013 8:56 AM