Filter
Top Products
1528 Management ACL Commands
permit priority
priority-value
•
gigabitethernet
unit/slot/port — A valid 1-gigabit Ethernet-routed port
number.
•
vlan
vlan-id
— A valid VLAN number.
•
port-channel
port-channel-number
— A valid port channel number.
•
tengigabitethernet
unit/slot/port — A valid 10-gigabit Ethernet-routed
port number.
•
fortygigabitethernet
unit/slot/port
–
A valid 40-gigabit Ethernet-routed
port number.
•
ip-address
— Source IP address.
•
mask
mask
— Specifies the network mask of the source IP address.
•
mask
prefix-length
— Specifies the number of bits that comprise the
source IP address prefix. The prefix length must be preceded by a forward
slash (/). (Range: 0–32)
•
service
service
— Indicates service type. Can be one of the following:
telnet
,
ssh
,
http
,
https
,
tftp
,
snmp
,
sntp
, or
any
. The
any
keyword indicates
that the service match for the ACL is effectively "don’t care".
•
priority
priority-value
— Priority for the rule. (Range: 1 – 64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with gigabitethernet, tengigabitethernet, fortygigabitethernet, vlan,
and port-channel parameters are valid only if an IP address is defined on the
appropriate interface. Ensure that each rule has a unique priority.
Examples
The following example shows how to configure two management interfaces,
gigabit Ethernet 1/0/1 and gigabit Ethernet 2/0/9.
2CSPC4.X8100-SWUM102.book Page 1528 Friday, March 15, 2013 8:56 AM