852 802.1x Commands
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following command sets the number of seconds that the switch waits for
a response to an EAP-request/identity frame to 3600 seconds.
console(config)# interface gigabitethernet 1/0/16
console(config-if-1/0/16)# dot1x timeout tx-period 3600
show dot1x
Use the show dot1x command in Privileged EXEC mode to display:
•
A summary of
the global dot1x configuration.
• Summary information of the dot1x configuration for a specified port or all
ports.
• Detailed dot1x configuration for a specified port
• Dot1x statistics for a specified port, depending on the tokens used.
Syntax
show dot1x [interface
interface-id
[statistics]]
Parameter Description
Default Configuration
This command has no default configuration.
Parameter Description
interface-id Any valid interface. See
Interface Naming Conventions
for
interface representation.
2CSPC4.X8100-SWUM102.book Page 852 Friday, March 15, 2013 8:56 AM