Port Monitor Commands 633
User Guidelines
The source of a monitoring session must be configured before the destination
can be configured. Only one session with a single destination is supported,
however, that session supports multiple sources.
Example
The following examples show a simple port level configuration that mirrors
both transmitted and received packet from one port to another.
console(config)#monitor session 1 source interface te1/0/8
console(config)#monitor session 1 destination interface te1/0/10
console(config)#monitor session 1 mode
show monitor session
Use the show monitor session command in Privileged EXEC mode to display
status of port monitoring.
Syntax
show monitor session
session_number
•
session
_number
— Session identification number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following examples shows port monitoring status.
console#show monitor session 1
2CSPC4.X8100-SWUM102.book Page 633 Friday, March 15, 2013 8:56 AM