IGMP Snooping Commands 473
Syntax
show ip igmp snooping mrouter
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example shows IGMP snooping mrouter information.
console#show ip igmp snooping mrouter
VLAN ID Port
------- -----------
10 Gi2/0/1
ip igmp snooping vlan immediate-leave
This command enables or disables IGMP Snooping immediate-leave mode
on a selected VLAN. Enabling immediate-leave allows the switch to
immediately remove the layer 2 LAN interface from its forwarding table entry
upon receiving an IGMP leave message for that multicast group without first
sending out MAC-based general queries to the interface. The no form of this
command disables IGMP Snooping immediate-leave mode on a VLAN.
You should enable immediate-leave admin mode only on VLANs where only
one host is connected to each layer 2 LAN port. This setting prevents the
inadvertent dropping of the other hosts that were connected to the same layer
2 LAN port but were still interested in receiving multicast traffic directed to
that group. Also, immediate-leave processing is supported only with IGMP
version 2 hosts.
2CSPC4.X8100-SWUM102.book Page 473 Friday, March 15, 2013 8:56 AM