Multicast VLAN Registration Commands 607
console#show mvr members 224.1.1.1
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE 1/0/1, 1/0/2, 1/0/3
show mvr interface
Use the show mvr interface command in Privileged EXEC mode to display
the MVR enabled interfaces configuration.
Syntax
show mvr interface [
interface-id
[members [vlan
vid
]]]
Parameter Description
The following table explains the output parameters.
Parameter Description
Interface-id Identifies a specific interface.
VID VLAN identifier.
Parameter Description
Port Interface number
Type The MVR port type. It can be None,
Receiver, or Source type.
Status The interface status. It consists of two
characteristics:
1
active
or
inactive
indicating if port is
forwarding.
2
inVLAN
or
notInVLAN
indicating if the
port is part of any VLAN
Immediate Leave The state of immediate mode. It can be
enabled or disabled.
2CSPC4.X8100-SWUM102.book Page 607 Friday, March 15, 2013 8:56 AM