Ethernet Configuration Commands 415
--More-- or (q)uit
The displayed port configuration information includes the following:
show interfaces counters
Use the show interfaces counters command in either User EXEC mode or
Privileged EXEC mode to display Priority Flow Control (PFC) traffic seen by
the interface, including Received PFC Frames and Transmitted PFC Frames
for a given ethernet or port-channel interface.
Syntax
show interfaces counters [gigabitethernet unit/slot/port |
port-channel
port-
channel-number
| tengigabitethernet unit/slot/port
| fortygigabitethernet
unit/slot/port]
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode,Privileged EXEC mode, Config mode and all Config sub-
modes
Field Description
Port The port number.
Port Type The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Admin State Displays whether the port is enabled or disabled.
2CSPC4.X8100-SWUM102.book Page 415 Friday, March 15, 2013 8:56 AM