IPv6 Multicast Commands 1191
•
vlan-id
—A valid VLAN ID value.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pim neighbor all
Slot/Port...................................... vlan 6
Neighbor Address............................... FE80::200:FF:FE00:33
Up Time (hh:mm:ss)............................. 00:00:12
Expiry Time (hh:mm:ss)......................... 00:01:34
DR Priority.................................... 0
show ipv6 pim rphash
Use the show ipv6 pim rphash command to display which rendezvous point
(RP) is being selected for a specified group.
Syntax
show ipv6 pim rphash
group-address
group-address
—Group IP address supported by RP.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
2CSPC4.X8100-SWUM102.book Page 1191 Friday, March 15, 2013 8:56 AM