Filter
Top Products
Command Groups 136
ip ospf cost
Configures the cost on an OSPF interface. IC
ip ospf dead-interval
l Sets the OSPF dead interval for the specified
interface.
IC
ip ospf hello-interval
Sets the OSPF hello interval for the specified
interface.
IC
ip ospf mtu-ignore
Disables OSPF maximum transmission unit
(MTU) mismatch detection.
IC
ip ospf network
Configure OSPF to treat an interface as a point-
to-point, rather than broadcast interface.
IC
ip ospf priority
Sets the OSPF priority for the specified router
interface.
IC
ip ospf retransmit-interval
Sets the OSPF retransmit Interval for the
specified interface.
IC
ip ospf transmit-delay
Sets the OSPF Transit Delay for the specified
interface.
IC
maximum-paths
Sets the number of paths that OSPF can report
for a given destination.
ROSPF
nsf
Enables OSPF graceful restart. ROSPF
nsf helper
Allow OSPF to act as a helpful neighbor for a
restarting router.
ROSPF
nsf helper strict-lsa-
checking
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
ROSPF
nsf restart-interval
Configures the length of the grace period on the
restarting router.
ROSPF
network area
Enables OSPFv2 on an interface and sets its area
ID if the IP address of an interface is covered by
this network command.
ROSPF
passive-interface
Sets the interface or tunnel as passive. IC
passive-interface default
Enables the global passive mode by default for all
interfaces.
ROSPF
passive-interface
Sets the interface or tunnel as passive. ROSPF
Command Description Mode
a
2CSPC4.X8100-SWUM102.book Page 136 Friday, March 15, 2013 8:56 AM