Filter
Top Products
880 Data Center Bridging Commands
User Guidelines
In auto mode, the switch will attempt to jump start the exchange by sending
an IEEE frame, followed by a CEE frame followed by a CIN frame. The
switch will parse the received response and immediately switch to the peer
version. Because LLDP is a link local protocol, it cannot be configured on a
port channel or VLAN interface. It is recommended that all ports configured
in a port channel utilize the same LLDP configuration.
Example
The following example configures the switch to use CEE DCBX.
s1(config)#lldp dcbx version cee
lldp tlv-select dcbxp (dcb enable)
Use the lldp tlv-select dcbxp command in Global Configuration or Interface
Configuration mode to enable the LLDP to send DCBX TLVs if LLDP is
enabled to transmit on the given interface. If no parameter is given, all DCBX
TLVs are enabled for transmission. The default is all DCBX TLVs are enabled
for transmission. If executed in Interface mode, the interface configuration
overrides the global configuration for that interface. Entering the command
with no parameters enables transmission of all TLVs.
Use the no form of the command to return the configuration to the default
settings.
Syntax
lldp tlv-select dcbxp [ets-config|ets-recommend|pfc|application-
priority|congestion-notification] [dcb enable]
no lldp tlv-select dcbxp [ets-config|ets-recommend|pfc|application-
priority|congestion-notification] [dcb enable]
Parameter Description
Parameter Description
Ets-config Transmit the ETS configuration TLV.
Ets-recommend Transmit the ETS recommendation TLV.
2CSPC4.X8100-SWUM102.book Page 880 Friday, March 15, 2013 8:56 AM