OSPFv3 Commands 1307
Syntax
exit-overflow-interval
seconds
no exit-overflow-interval
•
seconds
— Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for
seconds
.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100
seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPFv3 Configuration
mode to configure the external LSDB limit for OSPF. If the value is -1, then
there is no limit. When the number of non-default AS-external-LSAs in a
router's link-state database reaches the external LSDB limit, the router enters
overflow state. The router never holds more than the external LSDB limit
non-default AS-external- LSAs in it database. The external LSDB limit
MUST be set identically in all routers attached to the OSPF backbone and/or
any regular OSPF area.
Syntax
external-lsdb-limit
limit
no external-lsdb-limit
2CSPC4.X8100-SWUM102.book Page 1307 Friday, March 15, 2013 8:56 AM