Command Groups 146
Utility Commands
Auto-Install
Captive Portal
Command Description Mode
a
a. For the meaning of each Mode abbreviation, see
Mode Types
on page 81.
boot auto-copy-sw
Enables or disables Stack Firmware
Synchronization.
GC
boot auto-copy-sw allow-
downgrade
Enables downgrading the firmware version on
the stack member if the firmware version on the
manager is older than the firmware version on
the member.
GC
boot host autoreboot
Enables rebooting the device (no administrative
intervention) when the auto-image is
successfully downloaded.
GC
boot host autosave
Enables/disables automatically saving the
downloaded configuration on the switch.
GC
boot host dhcp
Enables/disables Auto Config on the switch. GC
boot host retrycount
Set the number of attempts to download a
configuration.
GC
show auto-copy-sw
Displays Stack Firmware Synchronization
configuration status.
PE
show boot
Displays the current status of the Auto Config
process.
PE
Command Description Mode
a
authentication timeout
Configures the authentication timeout. CP
captive-portal
Enables the captive portal configuration mode. GC
enable
Globally enables captive portal. CPI
http port
Configures an additional HTTP port for captive
portal to monitor.
CP
2CSPC4.X8100-SWUM102.book Page 146 Friday, March 15, 2013 8:56 AM