Filter
Top Products
107
www.gateway.com
Fibre channel module
* Beacon is used by the Qlogic SANSurfer FE HBA Manager software to identify a specific adapter in the system.
Option ROM
During the initial boot after installation of the fibre channel module, you will see the
following information displayed during the POST:
QLogic Corporation
QLA2322 PCI Fibre Channel ROM BIOS Version x.xx Subsystem Vendor ID 8086
Copyright (C) QLogic Corporation 1993-2003 All rights reserved.
www.qlogic.com
Press <CTRL-Q> for Fast!UTIL
BIOS for Adapter 1 is disabled
QLogic adapter using IRQ number 11
Checking Adapter 0 Loop 10 125
No Fibre devices found!
ROM BIOS NOT INSTALLED
Only enable the Option ROM if your primary boot device is attached to the fibre channel
module in your server.
Operating system driver installation and configuration
Refer to the readme.txt file included with the drive for specific information on installation.
For information on driver parameters, refer to Section 2, “Driver Parameters,” in the QLogic
document Troubleshooting Guide 2Gbps Fibre Channel Host Bus Adapters, available from
download.qlogic.com/manual/17851/FC0056702-00A.pdf
.
2 Gbps link established Two flashes every 4
seconds
Off Off
2 Gbps activity Two flashes every 4
seconds
On Off
Firmware error Varies Varies On
Beacon* Constant flash Constant flash Constant flash
Activity Green LED Orange LED Red LED
8510702.book Page 107 Thursday, July 7, 2005 11:21 AM