Filter
Top Products
219
www.gateway.com
LED information
■ Make sure that the last device on the SCSI cable is correctly terminated. For more
information about SCSI device configurations, see the device’s documentation.
■ Use a different SCSI cable.
The master boot record is corrupted
■ In a Windows network operating system, repair the master boot record using FDISK.
To repair the master boot record:
■ At a DOS command prompt, type fdisk/mbr, then press ENTER.
Internet
You cannot connect to the Internet
■ Make sure that your account with your Internet Service Provider (ISP) is set up
correctly. Contact your ISP technical support for help.
Keyboard
Liquid has been spilled into the keyboard
■ If you spilled liquid in the keyboard, turn off your server and unplug the keyboard.
Clean the keyboard and turn it upside down to drain it. Let the keyboard dry before
using it again. If the keyboard does not work after it dries, you may need to replace it.
This type of damage is not covered by your server’s warranty.
Memory
Memory errors were detected during server start up
■ Open your server and make sure that the memory modules are installed correctly. For
more information, see “Installing and removing DIMMs” on page 91.
■ A memory module may be defective. Check the LEDs on all of the memory boards
to make sure no fault LEDs are on. Replace the faulty memory.
8510702.book Page 219 Thursday, July 7, 2005 11:21 AM