Filter
Top Products
31
www.gateway.com
Configuring SCSI features
To access and change the Adapter Properties List:
1 Follow the instructions in “To access the LSI Logic MPT SCSI Setup Utility:” on page 27.
2 Use the up and down arrow keys to highlight the adapter to be configured, then press
E
NTER. The following message will be displayed:
Scanning for devices...
When the utility is finished scanning for devices, the Adapter Properties screen opens.
3 Use the up and down arrow keys to select options from the list and +/- to change
the settings:
■ <Device Properties> Takes you to the Device Properties screen
■ Host SCSI ID (0 to 15)
■ SCSI Bus Scan Order (Low to High (0 - Max) or High to Low (Max - 0))
■ Removable Media Support (None, Boot Drive Only, or With Media Installed)
■ CHS (Cylinder Head Sector) Mapping (SCSI Plug and Play Mapping or Alternate CHS
Mapping
)
■ Spinup Delay (Secs) (1 to 15)
Important
If the RAID on MotherBoard (ROMB) feature is not enabled, the
following message will be displayed:
Current firmware does not support IME RAID type. Press any
key to continue.
8510702.book Page 31 Thursday, July 7, 2005 11:21 AM