Filter
Top Products
160
www.gateway.com
Chapter 5: Using the BIOS Setup Utility
11 Follow the instructions in “Closing the server case” on page 72.
12 Plug in the AC power cords and turn on the server, then verify that the recovery was
successful.
To recover the default BIOS settings using front control panel buttons:
1 Turn off the server, but leave it connected to the AC power source.
2 Make sure that the NVRAM Clear jumper (J4A4) is in the default position (Not Clear).
3 Hold down the Reset button on the front control panel for at lease 4 seconds.
4 While continuing to hold down the Reset button, press the Power button.
5 Release both buttons at the same time. The BIOS reverts to the default settings.
Important
Check to make sure that the custom settings previously recorded and
entered are not causing the application problems before resetting the
BIOS.
8510702.book Page 160 Thursday, July 7, 2005 11:21 AM