Filter
Top Products
78
www.gateway.com
Chapter 4: Installing Components
If you are adding a new drive to an available 5.25-inch device bay, remove the filler
panel assembly from the bay by pressing and holding the two locking clips inward,
then pulling the filler panel assembly out of the bay.
4 Remove the drive rails from the filler panel assembly by removing the screws holding
the rails to the assembly, then go to Step 8.
5 Disconnect the old drive’s cables from the back of the drive.
6 Press the rail tabs against the drive, then pull the drive out of the bay.
7 Remove the screws that hold the drive rails to the old drive, then remove the rails.
8 Attach the rails to the new drive with the screws you just removed.
9 Set any jumpers on the new drive. See the drive’s documentation for further
instructions.
10 Connect the power and data cables to the drive. For the location of the connectors
on the system board, see “System board” on page 5. For additional drive information,
see the drive’s documentation.
8510702.book Page 78 Thursday, July 7, 2005 11:21 AM