Filter
Top Products
128
www.gateway.com
Chapter 4: Installing Components
9 Holding the DIMM by the edges, align the notch on the bottom edge of the DIMM
with the notch in the DIMM socket and press the DIMM firmly into the socket. The
tabs on the sides of the DIMM socket should secure the DIMM automatically.
10 Reinstall the PCI expansion card into PCI slot 7 (if removed) by following the
instructions in “Cold installation or removal of PCI expansion cards” on page 104.
11 Reinstall the memory board or memory board air baffle by following the instructions
in “Installing and removing memory boards” on page 85.
12 Replace the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67.
13 Follow the instructions in “Closing the server case” on page 72.
14 Configure the BIOS settings to enable the ROMB option.
To remove the RAID activation key and RAID DIMM:
1 Remove the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67.
2 Remove the memory board or memory board air baffle from slot C by following the
instructions in “Installing and removing memory boards” on page 85.
3 Remove the PCI expansion card from PCI slot 7 (if installed) by following the
instructions in “Cold installation or removal of PCI expansion cards” on page 104.
4 Insert the end of a small, flat-bladed screwdriver under the plastic tab on the snap-on
plastic retainer holding the RAID activation key on the system board, then gently pry
the key from the holder.
8510702.book Page 128 Thursday, July 7, 2005 11:21 AM