Filter
Top Products
88
www.gateway.com
Chapter 4: Installing Components
6 Pull up on the memory board handle and lift the memory board from the server.
7 Install or replace DIMMs on the memory board by following the instructions in
“Installing and removing DIMMs” on page 91.
8 Make sure the handle on the memory board is in the open/up position, then align
the ends of memory board with the card guides at each end and insert the memory
board into the memory board slot.
9 Push the memory board handle down into the locked position.
10 Follow the instructions in “Closing the server case” on page 72.
Important
Unlocking and lifting the memory board handle, then pulling the
handle to remove the memory board immediately disables power to
the memory slot. If the server is not correctly configured for hot
memory board replacement this will cause the operating system to
crash, but will not electrically damage the system.
8510702.book Page 88 Thursday, July 7, 2005 11:21 AM