Filter
Top Products
89
www.gateway.com
Memory
Cold removal and installation of memory boards
To remove/replace a memory board while the system is off:
1 Follow the instructions in “Preventing static electricity discharge” on page 65.
2 Follow the instructions in “Opening the server case” on page 66.
3 Press the latch on the memory board handle and lift the handle to unlock the memory
board.
4 Pull up on the memory board handle and lift the memory board from the server.
5 Install or replace DIMMs on the memory board by following the instructions in
“Installing and removing DIMMs” on page 91.
- OR -
Install a memory board air baffle into the open memory slot on the system board,
the proceed to Step 8.
6 Make sure the handle on the memory board is in the open/up position, then align
the ends of memory board with the card guides at each end and insert the memory
board into the memory board slot.
8510702.book Page 89 Thursday, July 7, 2005 11:21 AM