Filter
Top Products
215
www.gateway.com
LED information
Your CD or DVD drive tray does not open
■ Press a straightened paper clip wire into the CD or DVD drive’s manual eject hole.
The drive tray opens.
■ If this problem happens frequently while the server is turned on, the drive may be
defective.
Diskette drive
The diskette drive is not recognized
■ Restart your server.
■ Unplug and replug the USB cable from the drive to the server.
■ Try plugging the drive into a different computer
The diskette drive LED is lit continuously
■ Remove the diskette from the drive. If the light stays on, try restarting your server.
■ Unplug and replug the USB cable from the drive to the server.
■ Try plugging the drive into a different computer
USB flash memory device
Your server does not detect a USB flash memory device
■ Check to see if the USB flash memory device is shown in the Boot Maintenance
Manager.
■ Make sure the USB flash memory device is correctly inserted into the USB connector,
then reset the server. Do not remove the USB flash memory device while the server
reboots, then check the boot manager again.
If these suggestions do not work, do the following:
1 Create a small FAT partition (less than 64MB) on a system that is running
Windows XP.
2 Format the partition as FAT
3 Reinstall the USB flash memory device into a USB port on the server, then boot
the server to the DOS disk in the USB diskette drive.
4 Use FDISK.EXE to delete all of the partition and create a small partition for DOS.
Make sure the partition is set to active.
5 Turn the server off, then back on.
8510702.book Page 215 Thursday, July 7, 2005 11:21 AM