Filter
Top Products
121
www.gateway.com
Processors
4 Remove the memory boards or memory board air baffles from memory slots C and
D by following the instructions in “Installing and removing memory boards” on
page 85.
5 Remove the fibre channel module by following the instructions in “Installing or
removing the fibre channel module” on page 108.
6 If you are installing the VRM for the fourth processor, remove the VRM air baffle by
pushing down on the top of the baffle and pulling the baffle away at an angle from
the center brace.
7 Pull the plastic tabs away from the sides of the VRM socket.
8 Holding the VRM by the edges, align the notch on the bottom edge of the VRM with
the notch in the VRM socket and press the VRM firmly into the socket.
9 Make sure the tabs on the sides of the VRM socket close securely.
Caution
Do not use excessive force if the VRM converter does not install
easily. The notch in the VRM and the tab in the VRM socket are
designed to prevent incorrect installation. Forcing the wrong VRM into
the socket, or forcing the correct VRM into the socket incorrectly,
could result in damage to the VRM or the socket.
8510702.book Page 121 Thursday, July 7, 2005 11:21 AM