Filter
Top Products
151
www.gateway.com
Replacing the system board
16 Pull up the blue, spring-loaded plunger in the center of the board and slide the board
toward the back of the chassis until the I/O connectors engage the back panel, then
release the plunger.
17 Connect the three-cable bundle from the power distribution board to the power
connectors on the system board (see “System board” on page 5).
18 Connect the chassis intrusion switch cable to the system board.
19 Connect the internal SCSI connector to the system board.
20 Install the plastic PCI dividers onto the system board.
21 Install the center brace by following the instructions in “Removing and installing the
center brace” on page 69.
8510702.book Page 151 Thursday, July 7, 2005 11:21 AM