Filter
Top Products
13
www.gateway.com
Setting up the hardware
7 Align each of the casters with its screw hole on the (new) bottom of the server and
secure with one Phillips screw per caster (provided with caster assembly).
8 Remove the Torx screws securing the rack faceplate to the front of the chassis, then
remove the faceplate.
9 Align the screw holes in the pedestal faceplate with the holes on the front of the
chassis, then secure with the Torx screws you previously removed.
Insert and partially tighten four screws before inserting the remaining screws, then
fully tighten the screws.
Caster
Screw
Faceplate
Torx Screw
8510702.book Page 13 Thursday, July 7, 2005 11:21 AM