Filter
Top Products
217
www.gateway.com
LED information
Your server has a SCSI hard drive and a USB flash memory device installed and the
server continues to boot from the SCSI drive
The SCSI hard drive is set as the first Legacy Hard Disk Drive in the Legacy Hard disk drive
order.
To change the boot order:
1 Plug the USB flash memory device into a USB port on your server.
2 Boot the server.
3 When you see the Gateway Logo screen, press any key to access the System
Options menu.
4 When the System Options menu opens, use the down arrow key to select Boot
Maintenance Manager
, then press ENTER. The Boot Maintenance Manager menu opens.
5 Select Boot Options from the menu, then press ENTER.
6 Use the down arrow key to highlight Select Legacy Hard Drive Order, then press
E
NTER.
7 Use the down arrow key to highlight HardDisk Drive #00, then press ENTER.
8 Select Apply Changes, then press ENTER.
9 Press ESC repeatedly until the Boot Maintenance Manager menu opens.
10 Select Reset System, then press ENTER.
11 After the server has rebooted, access the System Options menu as described in
Step 3.
12 Select Boot Manager and make sure the USB flash memory device is shown as a
selectable boot device, then exit the menu.
Expansion cards
Your server does not recognize an expansion card
■ Restart your server.
Important
Make sure to document the boot order before it is changed. Also make
sure you have a backup of any data. After you have completed the
tasks with the USB flash memory device, reset the boot order back
to the original configuration.
8510702.book Page 217 Thursday, July 7, 2005 11:21 AM