Filter
Top Products
144
www.gateway.com
Chapter 4: Installing Components
7 Remove the new front panel I/O board from its package and place it in the chassis,
engaging the mounting tabs on the chassis with the slots in the new board.
8 Slide the front panel I/O board forward until it is seated on the mounting tabs, then
tighten the blue, captive thumbscrew to secure the board. See “Torque settings” on
page 64 for correct tightening specifications.
9 Connect the front panel I/O board and control panel cables to the new front panel
I/O board.
10 Reinstall the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67.
11 Follow the instructions in “Closing the server case” on page 72.
Important
Make sure that the pins on the front panel I/O board line up correctly
with the front panel cable connector.
Blue, captive thumbscrew
Mounting
tab
8510702.book Page 144 Thursday, July 7, 2005 11:21 AM