Filter
Top Products
To set default copy settings from the control panel
1 Make any needed changes to the Copy settings.
2 In the Copy area, press Menu until Set New Defaults appears.
3
Press
until Yes appears.
4 Press OK to accept the settings as the new default settings.
The settings you specify here are only saved on the HP all-in-one. They do not adjust
the settings in the software. You can save your most frequently used settings by using
the HP Image Zone software that came with your HP all-in-one. For more information,
see the onscreen HP Image Zone Help.
Make multiple copies of the same original
You can set the number of copies that you want to print by using the Number of
Copies option.
1 Make sure you have paper loaded in the input tray.
2 Load your original face down on the right front corner of the glass or face up in the
document feeder tray.
If you use the document feeder tray, place the pages so that the top of the
document goes in first.
3 In the Copy area, press Menu until Number of Copies appears.
4
Press
or use the keypad to enter the number of copies, up to the maximum.
(The maximum number of copies varies by model.)
Tip If you hold down either of the arrow buttons, the number of copies changes by
increments of 5 to make it easier to set a large number of copies.
5 Press Start Copy Black or Start Copy Color.
In this example, the HP all-in-one makes three copies of the original 10 by 15 cm (4
by 6 inch) photo.
Copy a two-page black-and-white document
You can use the HP all-in-one to copy a single- or multiple-page document in color or
black and white. In this example, the HP all-in-one is used to copy a two-page black-
and-white original.
Chapter 7
38 HP Officejet 6200 series all-in-one
Use the copy features