Filter
Top Products
28 2 Getting started EN
Installing a print cartridge
To install a print cartridge, use the following steps:
CAUTION
To prevent damage to the print cartridge, do not expose it to light for
more than a few minutes.
1 Make sure the print cartridge door is open.
2 Remove the print cartridge from its packaging, and locate the
sealing tape at the end of the cartridge.
3 To remove the sealing tape from the cartridge, grasp the tape and
pull it straight out from the cartridge. Avoid touching any black toner
on the tape.
4 Insert the cartridge as shown, with the arrows pointing into the
product.
5 Close the print cartridge door. The print cartridge engages when
the door is closed.
Note
If toner gets on your clothing or other fabric, wipe off the toner with a dry
cloth. Wash the items in cold water and air dry.
CAUTION
Hot water or heat from a dryer can set toner into fabric.
Hewlett-Packard Company cannot recommend the use of non-HP print
cartridges, either new, refilled, or remanufactured. Since they are not
HP products, HP cannot influence their design or control their quality.
4
2
3
1
5