Muratec MFX-1300/1700 All in One Printer User Manual


 
Just in case
What you see on the
LCD
What it means/What to do
Too Many Steps You tried to enter too many steps for a macro. Y ou
can enter up to 60 step s into a macro key.
Unable to Reduce In the reduction copy using the
ADF
, if the
calculated ratio is smaller than minimum reduction
ratio (50%), this message will appear and you can -
not make the reduction copy.
Use the
FBS
glass, however part s of the image
might not be copied.
Use FBS Glass You tried to enlargement copy using the
ADF
.
Your machine cannot enlargement copy from the
ADF
. Please set your document on the
FBS
glass to
make the enlargement copy.
Errors
When sending faxes, your machine occasionally runs into communications errors. These
can be caused by anything from lightning to telephone line interference. (These same
factors cause the st atic, or line noise, you sometimes hear on phone calls.) They also
can be caused by problems with the fax machine at the other end of the line.
Of ten, simply trying your call again is all that s necessary. However, if the problem per -
sist s regularly, call your local telephone company for help. If that doesn t help and the
problem persists regularly , call your authorized Muratec dealer.
Error report s
When an error occurs, your fax machine prints an error report. Each fax error report list s
an error message which includes:
A possible solution to the problem
The sending location (if the remote fax stores a Location
ID
of its own)
The result which is a special error code.
A sample of the document s first p age.
Kinds of error codes
The error code listed in the Result column of the error report indicates the specific
problem encountered:
D
codes Occur while dialing
R
codes Occur during reception
T
codes Occur during transmission
S pecific errors
Following are some error codes you may see on an error report:
Dialing errors
D
.0.3, The remote unit didn t respond, the call couldn t be completed or
STO P
was
D
.0.8 pressed during dialing. Re-try the call. If your machine repeat s the message,
call the remote fax unit s operator and verify that unit is operating properly.
D
.0.2 The remote unit is busy. T ry the call again.
D
.0.6, Either the remote unit didn t respond, the call somehow didn t go through or
D
.0.7
STO P
was pressed during dialing. Try the call again.
5.9