Muratec MFX-1300/1700 All in One Printer User Manual


 
1.8
Getting st arted
T urning of f the transport mode
Important: After unlocking the mirror carriage (see p age 1.5), you must turn the
transport mode off by following procedures.
When the machine is in the transport mode, the
LCD
shows:
To turn of f the transport mode:
1
Press Program key, *,
E
.
2
Select Off by pressing or . Then press
ENTER
to turn of f the transport mode.
The mirror carriage will move to the home position.
Important: If you must reship the machine, turn on this mode to move the mirror car-
riage to the transport position (in step 2, above, press or to set the
transport mode to O n ), then power of f and lock the mirror carriage using
the mirror carriage locking plate (see p age 1.5).
Adjust the monitor speaker s volume
You can set the volume of the monitor speaker.
1
Press
MONITO R
/
CALL
on the control p anel. Y ou now should hear a dial tone.
And press or of the cursor key. The
LCD
indicates the volume:
2
To turn the volume up, press .
To turn the volume down, press .
3
Press
MONITO R
/
CALL
again to hang up.
Loading paper
Acceptable p aper size and cassette cap acity
Paper source Paper type Paper size C a pacity
Paper cassette Plain paper*
1
Letter , Legal , Half-letter 500 sheets
Letter , Legal , Half-letter ,
Plain p aper*
1
A4 , A5 , A 6 , F4 , 50 sheet s
B yp ass T ray Executive , Custom-sized*
2
Envelopes D L , CM10 , Monarch 1 sheet
Postcard 3.9″ × 5.8 (100 × 148mm) 20 sheets
Transparency*
3
Letter 20 sheet s
*
1
Paper weight: 60 90 g/m
2
*
2
(3.8 8.5) inches (5.5 14.0) inches (Wid th Length) : It only can use if the optional
Printer Controller is att ached.
*
3
W e recommend: 3M PP2500 for laser printers or equivalent
Note: Do not use any paper which has been creased, wrinkled or has absorbed any
moisture.
Loading p aper in p aper cassette
Before you load paper, note the following:
Af ter you loaded paper in p aper cassette, you must need to tell your machine
which size of the p aper, letter-, legal- or half letter-sized, you loaded.
Y ou can do this by the Setting of the paper size operation. (See next p age.)
Note: If you will be using letter-sized p aper, there s no need to adjust the cassette;
your machine is initially set for Letter-sized p aper. Simply att ach the LT R
sticker to the out side of the p aper cassette.
1
Open the paper cassette from the front of your machine by gently pulling it toward
you.
** Tel Mode **
Volume:
Mirror Locked :Off
/
/Enter
Mirror Locked :On
/
/Enter
Mirror Locked