Filter
Top Products
Reception errors
R
.1.1 The calling fax machine didn t respond to your fax machine. This can happen if
someone dials a wrong number or if the remote machine restricts access
through use of a p asscode.
R
.1.2 The two fax machines were incompatible. Your fax machine sends and receives
only
ITU
-
T
Group 3 (see Glossary, p age 5.18) fax communication, the industry
standard since the early 1980s.
R
.1.4 Someone pressed
STO P
at the receiving fax machine.
R
.2.3 Poor phone line conditions made fax communication impossible. Call someone
at the remote machine s location.
R
.3.1 The sending fax machine detected too many errors from the receiving
fax machine.
R
.3.3 The sending fax machine is incompatible or had a document feeder problem
during transmission.
R
.3.4 Poor phone line conditions may have prevented your fax machine from properly
printing some or all of the p ages it received.
R
.4.2 Either the line disconnected before transmission or the transmitting fax machine
needs maintenance.
R
.4.4 The fax machine has reached its memory capacity .
R
.5.1,
ECM
reception failed (perhap s due to line noise).
R
.5.2
R
.8.1 A compatibility error occurred.
R
.8.10 Line noise or other problems prevented line probing.
R
.8.11 The fax machine timed out while waiting for the retrain signal.
Transmission errors
T
.1.1 The remote fax machine didn t respond to your machine. Call someone at the
remote machine s location.
T
.1.2 Your fax machine s page counter detected a possible document feeder error.
Carefully put the document back into the feeder and try the call again.
T
.1.4
STO P
was pressed during transmission.
T
.2.1 Either the phone line disconnected during transmission or fax communication
became impossible due to bad phone line conditions. Try the call again.
T
.2.2 The two fax machines were incompatible. Your fax machine sends and receives
only
ITU
-
T
Group 3 (see Glossary, page 5.18) fax communication, the industry
standard since the early 1980s.
T
.2.3 Bad phone line conditions made fax communication impossible. Conditions can
change rapidly, so try the call again later .
T
.3.1 The page counter in your fax machine detected a document feeder error during
transmission. Carefully re-insert the document into the feeder and re-try the call.
T
.3.2 The fax machine didn t detect the silence indicating the call had ended.
T
.4.1 The telephone line disconnected during transmission because of excessive
modem errors or because remote unit ran out of paper.Try the call again.
T
.4.2 After transmission began, poor line conditions developed. Try the call again.
T
.4.4 Poor line conditions prevented transmission. Try the call again.
T
.5.1,
ECM
transmission failed (perhap s due to line noise). Conditions can change
T
.5.2, rapidly , so try the call again later .
T
.5.3
T
.8.1 A compatibility error occurred.
T
.8.10 Line noise or other problems prevented line probing.
T
.8.11 The remote fax machine didn t complete the equalizer training phase.
Just in case
5.10